Toro 31527 Installation Instructions Manual page 10

Installing the Tank Hose
Important:
This procedure is necessary if you
install the 4WD switch.
1. Remove the temporary cap from the bulkhead
fitting and thread the angled end of the tank
hose onto the bulkhead fitting.
Figure 12
Bottom View
1. Hydraulic tank fitting
2. Tank hose
Note:
Ensure clearance for the coils by facing
the angled end and hose out toward the right
side of the machine, perpendicular to the frame.
2. Remove the temporary cap from the fitting on
the hydraulic fluid tank, and thread the straight
end of the tank hose onto the fitting.
3. Tighten the forward, straight end attached to the
tank to 50 to 64 N∙m (37 to 47 ft-lb).
4. Tighten the angled end attached to the bulkhead
to 81 to 100 N∙m (60 to 74 ft-lb).
g205309
3. Bulkhead fitting
10