Toro 31527 Installation Instructions Manual page 13

4. Secure the red wire labeled BYPASS ENGAGE
SWITCH 2 to the override switch center terminal
number 2 (Figure 17
5. Secure the gray wire labeled BYPASS ENGAGE
SWITCH 1 to the override switch rear terminal
number 1 (Figure 17
Important:
Incorrect switch wiring can
result in damage to the hydraulic system.
Verify that the wiring is installed correctly;
refer to Testing the Four-Wheel Drive (page
18).
Figure 18
1. Spring-loaded to the rear
of the switch
2. Toggle switch
3. Gray wire
4. Red wire
6. Route the toggle switch with the connected
wire harness into the rear of the center console
(Figure 19).
and Figure 18).
and Figure 18).
5. Front terminal
6. Center terminal
7. Rear terminal
1. Toggle switch
7. Pull the toggle switch/wire harness through the
center console up to the drilled hole
g273521
1. Rear of center console
8. Install the toggle switch into the 13 mm (1/2
inch) hole from the bottom of the console; refer
to Figure 21
washer orientation.
Note:
Install the switch spring-loaded toward
the rear of the machine.
Discard the tabbed washer included with the
toggle switch.
13
Figure 19
2. Rear of center console
Figure 20
2. Toggle switch
for the correct hex locknut and
g035968
(Figure 20).
g035969