Table of Contents
Advertisement
Checking for Hydraulic Leaks
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Make sure that all hydraulic fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
• Keep your body and hands away from
pin hole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Get immediate medical help if fluid is
injected into the skin.
1.
Check and tighten all fittings and hydraulic
connections.
2.
Ensure that the hydraulic pump bypass valve is
in the operation position; refer to the pushing or
towing the machine instructions in the Operator's
Manual.
3.
Check the hydraulic-fluid level and replenish it
as required; refer to the Operator's Manual for
your machine.
4.
Start the machine and allow the hydraulic
system to pressurize.
5.
Shut off the engine and check the hydraulic
tubes, hoses, and fittings for leaks.
Note:
Repair all leaks before operating the
machine.
Important:
This completes the installation.
Testing the Four-Wheel Drive
1.
Place the key into the switch, turn the key to the
O
position, and disengage the parking brake.
N
2.
Drive the machine forward and press the 4WD
toggle switch forward.
Note:
You should hear the solenoids shift if the
kit is installed properly. If you do not, check the
wire harness connections and fuse placement.
3.
Make a tight turn with the switch pressed
forward.
Note:
You should feel the 4WD if the kit is
installed properly. If you do not, check the wire
harness connections and fuse placement.
18
Advertisement
Table of Contents
