universalblue UAA3000R32-19 Instruction Manual page 57

Connecting the indoor unit
• Remove the cap that covers the piping from
the indoor unit.
• Insert the nut, as shown in the picture.
• Tighten the connections using a wrench
tightening in betting directions
Water drainage
The drainage of the condensed water is
fundamental for a correct installation.
• Place the drain hose under the pipe.
• The drain pipe must be inclined to allow
water to drain.
• Do not bend the drain pipe or place the
end of the pipe submerged in water.
• If the pipe is installed on the right, the
pipes, electrical cables and drain pipe
must be installed behind the unit with a
connecting pipe.
• Insert the connection tube into the
corresponding slot.
• Press for unit the tube to the base.
After connecting the piping according to the
instructions, install the connecting cables. Now
install the drain pipe. After connection, cover the
pipe, cables and drain pipe with insulating material.
• Position pipes,
securely.
• Cover pipe joints with insulating material and
secure with tape.
• Pass the attached pipe, cables, and drain pipe
through the hole in the wall and mount the
cables and drain hose
57