Wallenstein CT162 Operator's Manual page 35

CT16 / CT24
Trailer Firewood Conveyor
6.3.4 Hydraulic Filter, Changing
1. The hydraulic system return filter is the spin-on type.
Remove the filter and dispose of it in an environmentally
friendly manner.
Fig. 41 – Hydraulic Oil Filter
2. Wet around the seal on the new filter with clean oil.
Fig. 42 – Oil the Seal
3. Turn the new filter on by hand until it is snug, then tighten
another 1/4 turn. Wipe off any oil residue on the filter and
filter head.
4. Fill the reservoir with clean, new oil. Verify the oil level
using the dipstick. The oil level should be at the upper
mark.
2
00537
1. Full Oil Level Mark
2. Low Oil Level Mark
3. Oil Level Dipstick
00538
35
Accessory Hydraulic Power Pack
1
3
Fig. 43 – Hydraulic Oil Level
00536