Wallenstein CT162 Operator's Manual page 30

Accessory Hydraulic Power Pack
DO NOT tamper with governor springs, governor links or other
parts which may increase the governed speed.
DO NOT tamper with the engine as set by the original equipment
manufacturer.
DO NOT check for spark with spark plug or spark plug wire
removed.
DO NOT crank engine with spark plug removed. If engine is
flooded, crank until engine starts.
DO NOT operate engine without a muffler. Inspect periodically
and replace if necessary.
DO NOT operate engine with an accumulation of grass, leaves,
dirt or other combustible materials in the muffler area.
DO NOT use this engine on any forest covered, brush covered,
or grass covered unimproved land unless a spark arrester is
installed on the muffler. The arrester must be maintained in
effective working order by the operator. In the state of California,
the above is required by law (Section 4442 of the California
Public Resources Code). Other states may have similar laws.
Federal laws apply on federal land.
DO NOT touch hot muffler, engine body or cooling fins. Contact
may cause burns.
DO NOT run engine with air cleaner or air cleaner cover
removed.
Be sure to:
Remove the wire from the spark plug when servicing the engine
or equipment to prevent accidental starting. Disconnect the (-)
ground wire from the battery terminal.
Keep engine cooling fins and governor parts free of grass and
other debris that can affect engine speed.
Use fresh gasoline. Old fuel can clog carburetor and cause
leakage.
Check fuel lines and fittings frequently for cracks or leaks.
Replace if necessary.
6.2.1 Pre-start Checks
Engine Oil Level Check
Check engine oil level daily.
Check with the machine parked on level ground and the engine
stopped.
IMPORTANT! Running the engine with a low oil level can
cause engine damage that is not covered by warranty.
1. Remove the oil level dipstick and wipe it clean.
2. Fully insert the oil level dipstick, then remove it to check the
oil level. The proper level is when the oil is visible at the
full (upper) mark on the dipstick.
3. If the oil level is low, add oil until the level is at the full mark.
SAE 10W-30 is recommended for general use.
4. Reinstall the oil level dipstick.
3
Fig. 32 – Engine Oil Level check
1. Oil Level Dipstick
2. Oil Filler
3. Low Oil Level
4. Full Mark
Fuel Level Check
Check the fuel level daily.
Starting with a full tank helps to eliminate or reduce operating
interruptions for refueling.
The fuel tank is located on the engine. Avoid running the tank
dry.
30
Trailer Firewood Conveyor
1
2
4
CT16 / CT24
00454