Wallenstein CT162 Operator's Manual page 33

CT16 / CT24
Trailer Firewood Conveyor
2. If the engine is cold, close the choke (push choke lever
to the left). To start a warm engine, leave the choke open
(lever pushed to the right).
3
Fig. 37 – Choke Lever
1. Choke Lever
2. Choke OPEN
3. Choke CLOSED
3. Move the throttle lever away from the MIN. position, about
1/3 of the way toward the MAX position.
4. Turn the engine ignition switch ON.
Fig. 38 – Ignition Switch
5. Pull the starter grip out lightly until resistance is felt, then
pull briskly in the direction of the arrow as shown below.
Return the starter grip gently.
1
2
00188
00187
Accessory Hydraulic Power Pack
Fig. 39 – Recoil Starter
IMPORTANT! Do not allow the starter grip to snap back
against the engine. Return it gently to prevent damage to the
starter.
6. Leave the engine operating at low throttle for a few minutes
to allow it to warm up. Gradually push the choke control
lever open (to the left) as the engine warms.
IMPORTANT! Engine should be warmed up before putting to
work.
7. Once the engine is warmed, increase throttle as required.
Adjust engine speed to preferred conveyor off-load speed.
6.2.3 Stopping Procedure
In an emergency
• Turn the ignition switch OFF.
• Correct fault situation before restarting engine and
resuming work.
Under normal conditions, use the following procedure. Refer to
the engine manual for further information
1. Stop loading material onto the conveyor.
2. Decrease engine speed to MIN.
3. Turn the ignition switch OFF.
33
00192