Wallenstein CT162 Operator's Manual page 32

Accessory Hydraulic Power Pack
Hydraulic Oil Level Check
Check hydraulic oil level daily with the engine stopped.
Pull out the dipstick to check the oil level. The correct level is
when the oil is at the upper mark on the dipstick. Add oil as
required.
IMPORTANT! Do not operate machine if oil level is low.
Damage to the pump and other components can occur.
IMPORTANT! Hydraulic oil quality should be inspected
every 50 hours. If the oil is dirty or smells burnt, it should be
replaced.
1
2
3
Fig. 35 – Hydraulic Oil Level Check
1. High Oil Level Indicator Mark
2. Low Oil Level Mark
3. Oil level Dipstick in Reservoir
Adding Oil to the Tank
The hydraulic system uses Dexron® III ATF.
7. Clean the area around filler cap and remove it.
8. Use a clean funnel to add oil. Check the level by inserting
the dipstick then removing it to examine.
9. Install filler cap securely afterward. Wipe up any spilled oil.
Check levels after changing filters or servicing hydraulic
components.
6.2.2 Starting the Engine
Before starting engine, review the operating and
maintenance instructions in the engine manual.
Engine exhaust contains carbon monoxide, an
odorless, poisonous gas. Breathing it can cause
unconsciousness or death.
Never operate this engine in a closed, or even
partly closed area. Exhaust gases can build up to
dangerous levels.
Make sure the conveyor is set up to work and otherwise ready
to run.
1. Slide the fuel valve lever toward the block (2) to turn fuel
ON.
00536
1. Fuel Shut-off Valve Lever
2. ON Position
3. OFF Position
32
CAUTION!
WARNING!
CAUTION!
Hearing loss hazard. Prolonged
exposure to loud noise may cause
permanent hearing loss. Use suitable
protection while operating the
machine.
3
Fig. 36 – Fuel Valve Lever
CT16 / CT24
Trailer Firewood Conveyor
W019
W072
W016
1
00190
2