Loop-1 Sp-Related Setting (D2701 To D2800) - Automationdirect.com prosense PPC5 Series User Manual

Loop-1 SP-related Setting (D2701 to D2800)

Register
No.
D2701 RMS_L1
D2702 RFL_L1
D2703 RT_L1
D2704 RBS_L1
D2705 UPR_L1
D2706 DNR_L1
TMU_L1
D2707
D2708 to D2709
D2710 SPT_L1
D2711 PVT_L1
D2714 to D2800
PPC Manual Revision 1
Description
Remote input method
Remote input filter
Remote input ratio
Remote input bias
SP ramp-up rate
SP ramp-down rate
SP ramp-rate time unit
SP tracking selection
PV tracking selection
Chapter 23: D Registers (Holding Registers)
Range and meaning of value
0: RSP (Via remote (aux. analog) input)
1: COM (Via communication)
RSP is not displayed if the remote (auxiliary analog)
input is not specified.
COM is not displayed if the communication function
is not specified.
When neither the remote (auxiliary analog) input
nor communication function is specified, this
parameter is not displayed.
0: OFF (Disable)
1 to 120 s
SP = Remote input x RT + Remote input bias
0.001 to 9.999
-100.0 to 100.0% of PV input range span (EU)
Used to prevent SP from changing suddenly.
Set a ramp-up rate or ramp-down rate per hour or
minute. Set a time unit using the parameter TMU.
0: OFF (Disable)
0.0 + 1 digit to 100.0% of PV input range span (EU)
0: HOUR (Ramp-up rate or ramp-down rate per
hour)
1: MIN (Ramp-up rate or ramp-down rate per
minute)
Tracking is performed when the mode changes
from Remote to Local. (The local setpoint keeps
track of the remote setpoint.)
0: OFF (Disable)
1: ON (Enable)
Causes the setpoint to keep track of the PV so the
setpoint automatically reverts to its original value at
a preset rate of change. The UPR, DNR, and TMU
are used in combination.
Operating conditions:
1) MAN → AUTO, 2) STOP → AUTO,
3) Power-on, 4) SP number change,
5) SP change
0: OFF (Disable)
1: ON (Enable)
23-25