Installing The Main Board, Subframe And Radio Card (5 Ghz) - Welch Allyn Micropaq 406 Service Manual

44 Repair procedures

Installing the main board, subframe and radio card (5 GHz)

1. Place the main board subassembly (main board, subframe and radio card) with the
radio-card side down to the left of the front case as shown.
2. Place the antenna board in the front case and line up the screw hole. Route the black
wire out of the side of the antenna board and the gray wire out of the bottom of the
antenna board.
Welch Allyn Micropaq Monitor
Antenna board screw hole