Installing The Spo 2 Board (Nellcor Models) - Welch Allyn Micropaq 406 Service Manual

54 Repair procedures
Installing the SpO
This section covers installation of the SpO
go to "Installing the SpO
1. Plug the SpO
board (Nellcor models)
2
board (Masimo models)"
2
Caution When connecting the SpO2 cable from the rear case, open the case
120 degrees and support the rear case as shown below to prevent stress on the
SpO flex cable.
2
cables into connectors J1 and J2.
2
J1
board on Nellcor models. For Masimo models,
2
on page 53.
J2
Welch Allyn Micropaq Monitor