Dryer Disposal - Maytag Commercial MDG28PD Installation Instructions Manual

Do not reach into the dryer if the drum is moving.
ʼn
Opening the dryer door will stop the function of the dryer.
ʼn
When loading or re-loading the dryer, avoid touching hot
ʼn
metal parts of the drum (burn risk).
Remove all objects from pockets such as lighters and
ʼn
matches.
Only authorized spare parts shall be used in the event of
ʼn
failure.
This appliance incorporates an earth connection for
ʼn
functional purposes only.
The dryer must not be installed behind a lockable door,
ʼn
a sliding door or a door with a hinge on the opposite
side to that of the tumble dryer, in such a way that a full
opening of the tumble dryer door is restricted.
Exhaust air must not be discharged into a flue which is
ʼn
used for exhausting fumes from appliances burning gas
or other fuels.
The fresh air ventilation openings into the room and into
ʼn
the dryer must not be blocked or sealed.
Emergency stop control: After installation, access to
ʼn
mains plug or disconnection from mains supply via a
double-pole switch must be ensured at all times in order
to ensure immediate deactivation of the dryer in case of
emergency.
The interior of the dryer and dryer exhaust vent should be
ʼn
cleaned periodically by qualified service personnel.
See "Electrical Requirements" section for earthing
ʼn
instructions.
This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment
(WEEE).
By ensuring this product is disposed of correctly, you will help avoid potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be
treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical
and electronic equipment.
Disposal must be carried out in accordance with local environmental regulations for waste disposal.
For more detailed information about treatment, recovery and recycling of this product, please contact your local city of ce,
your household waste disposal service or the shop where you purchased the product.
MODEL NOMENCLATURE:
MDG – Maytag Dryer – Gas
## (e.g. 28) – Model Type Number PD – Electronic Control – Coin Drop Enabled
6
SAVE THESE INSTRUCTIONS
PN – Electronic Control – Non-Pay
PR - Electronic Control - Card Ready
Adequate ventilation has to be provided to avoid the
ʼn
back-flow of gases into the room from appliances burning
fuels, including open fires.
The dryer shall be disconnected from its power source
ʼn
during service and when replacing parts.
If this is not possible due to the construction of the dryer
ʼn
or its installation, a disconnection with a locking system
in the isolated position shall be provided.
See DIMENSIONS/CLEARANCES section for minimum
ʼn
installation spacing requirements.
IEC Load Capacity: 10.5 kg.
ʼn
This dryer is not fitted with a supply cord and a plug.
ʼn
Means for disconnection from the supply mains having
a contact separation in all poles that provide full
disconnection under overvoltage category III conditions
must be provided, otherwise means for disconnection
must be incorporated in the fixed wiring in accordance
with the wiring rules.
Do not use an unlined masonry chimney as the flue for
ʼn
this appliance.
If an error code is displayed, contact the owner. The
ʼn
owner shall call service.
Do not use or store flammable materials in or near this
ʼn
appliance.
Do not place articles on or against this appliance.
ʼn
Exhaust air shall not be discharged into a flue which is
ʼn
used for other appliances.
means that care is required to avoid causing a fire
ʼn
by igniting flammable material.
DRYER SAFETY

DRYER DISPOSAL