Advertisement
1.6.2 Controller
・ CR2QA-701, CR3Q-701M/701
*1）
Cable
･ 2Q-TUCBL 10M
(TU Cable for robot)
･ 2Q-DISPCBL10M
(DISP Cable for robot )
･ 2Q-EMICBL 10M
(EMI Cable for robot)
･ MR-J3BUS10M-A10M
2A-RZ365(Sink)/
2A-RZ375(Source)
*5) Corresponding to the sink or source to be
used, setting of the drive unit is necessary.
*)Refer
(SSCNET Ⅲ Cable for robot)
toTable
1-4
for USB
cable.
［
］
*1)The base board, the power supply unit, and sequencer CPU are required
for installation of the robot CPU unit.
Prepared by customer
*2) The controller of "-S300" specification is CR2QA-701.
*3) The controller of CE Marking specification
"-S12" specification: the controller is CR3Q-700 series.
"-S312" specification: the controller is CR2QA-700 series.
The previous R28TB can be used if the relay connector box is used.
*4)
And, since the R28TB operation method is the same as before, refer
to the instructions manual which on hand.
General configuration
1
*4）
(MS-Windows2000/XP/Vista)
(MS-Windows2000/XP/Vista)
Advertisement
