Table of Contents
Advertisement
D
5 20 /C5 20W /C32 0 Op era tio n M anu al
P M - C
4.4.3
Advanced Wi-Fi Setup
Use DPMSoft to set up the router that DPM-C520W is going to connect, for example router's SSID and
password. And after that you can use the specific information to search for the router that DPM-C520W can
connect to.
Setting points:
1.
Use Ethernet cable to connect to your PC and router to avoid unreliable connection and packet lost during
transmission.
2.
In DPMSoft, the settings for data transmission are shown below.
Transmission Time: 2 seconds per data
Timeout: 3 seconds
_4
Failure: after 3 attempts
If data transmission fails, you need to search and try connecting to DPM-C502W again.
If you are using other meter-monitoring software, it is suggested to set the same settings for data
transmission.
3.
Network settings
Firmware Version
V1.0008 or
previous versions
V1.0008
(V1.0008 included)
or later
Default values
4.
Station number setting
For V1.0008 or previous versions:
Once you enter the station number, the station shows in the later section of the IP address.
For example, if you enter 1 in the field of the station, the IP address is 192.168.1.1.
4 - 2 0
SSID
Router Password
N/A
8~16 characters
1~32 characters
(optional)
WiFi_Modbus_001
1234567890
IP Address
N/A
192.168.X.X
AAA.BBB.XXX.YYY
(range: 1~255)
192.168.1.1
Keep Alive Time
N/A
5~9999 sec
100 sec
Advertisement
Table of Contents
