Unpacking; Accessory List - Craftsman 12 IN. COMPOUND MITER SAW 315.21222 Owner's Manual

YourCompound M iterSawhasbeenshipped
completely a ssembled e xcept f ortheaccessories,
blade, m iterlockhandle, a nddustguideor dustbag.
,_ WARNING:If anypartsaremissing, d onot
operate thistooluntilthemissing partsare
replaced. Failure to dosocouldresultin possible
serious personal injury.
• Remove allloosepartsfromthecarton. S eparate
andcheck withthelistofloose parts.
See Figure 2.
• Remove the packing materials from around your
saw.
Carefully lift saw from the carton and place it on a
level work surface. This saw is heavy. To avoid
back injury, get help when needed.
• Do not discard the packing materials until you have
carefully inspected the saw, identified all loose
parts, and satisfactorily operated your new saw.
• Your saw has been shipped with the saw arm
locked in the down position. To release saw arm,
push down on top of saw arm and pull out the lock
pin. See Figure 4.
• Hand pressure should remain on the saw arm to
prevent sudden rise upon release of the lock pin.
• Examine all parts to make sure no breakage or
damage has occurred during shipping.
If any parts are damaged or missing, do not attempt to
plug in the power cord and turn the switch on until the
damaged or missing parts are obtained and are
installed correctly.
The following accessories are included with your Compound Miter Saw:
• Dust Bag
• Table Extensions (2)
• Stop Block
• Small Wing Screw
• Work Clamp Assembly
• Clamp Extension Rod
• Clamp Support
• Clamp Bracket (2)
• Clamp Bracket Screw (2)
• Small Screw (4)
CLAMPS_ SCREWS
CLAMP
EXTENSION ROD
sc
DUSTBAG
WORKCLAMP
ASSEMBLY
SCREW
%
CLAMP
BRACKETS
STOP
SMALL
WINGSCREW
TABLE
EXTENSION CLAMP
KETSCREW
TABLE
EXTENSION