Cutting A Slot In The Zero Clearance Throat Plate; Squaring The Miter Table To The Fence - Craftsman 12 IN. COMPOUND MITER SAW 315.21222 Owner's Manual

Note:Manyoftheillustrations i nthismanual s how
onlyportions ofyourcompound m itersaw.Thisis
intentional sothatwecanclearly showpoints being
madeinthe illustrations. Never o perate yoursaw
without a llguards securely in placeandingood
operating condition.
CUTTING A SLOT IN THE ZERO
CLEARANCE THROAT PLATE
In order to use your compound miter saw, you must
cut a slot through the zero clearance throat plate to
allow for blade clearance. To cut the slot, set your
saw at 0 degrees miter, turn saw on and allow the
blade to reach full speed, then carefully make a
straight cut as far as it will go through the throat plate.
Turn your saw off and allow the blade to come to a
complete stop before raising the saw arm.
Next, adjust the bevel angle to 45 degrees, turn your
saw on and allow the blade to reach full speed, then
carefully make another cut through the zero clearance
throat plate. The slot in the throat plate will then be
wide enough to allow the blade to pass through it at
any angle from 0 to 45 degrees.
SQUARING THE MITER TABLE
TO THE FENCE
See Figures 13- 16.
• Unplug your saw.
WARNING: Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
• Push down on the saw arm and pull out the lock
pin to release the saw arm.
• Raise saw arm to its full raised position.
• Loosen the miter lock handle approximately one-
half turn.
Depress the miter lock plate and rotate the miter
table until the pointer on the control arm is posi-
tioned at 0°.
Release the miter lock plate and securely tighten
the miter lock handle.
Lay a framing square flat on the miter table. Place
one leg of the square against the fence. Place the
other leg of the square beside the zero clearance
throat plate in the miter table. The edge of the
square and the zero clearance throat plate in
the miter table should be parallel as shown in
figure 13.
If the edge of the framing square and the zero
clearance throat plate in the miter table are not
parallel as shown in figures 14 and 15, adjust-
ments are needed.
FRAMING
SQUARE
\
FENCE
MITERTABLE
ZERO CLEARANCE
THROAT PLATE
MITER
LOCKPLATE
MITER
LOCKHANDLE
VIEW OF MITERTABLESQUAREWITH FENCE
AND CORRECTLY ADJUSTED
Fig. 13
FENCE
MITERTABLE
FRAMING ZEROCLEARANCE
SQUARE THROATPLATE
VIEW OFMITERTABLENOT SQUAREWITH
FENCE,ADJUSTMENTS ARE REQUIRED
Fig. 14
FENCE
MITERTABLE
FRAMING ZERO CLEARANCE
SQUARE THROATPLATE
VIEWOF MITERTABLE NOT SQUAREWITH
FENCE,ADJUSTMENTS ARE REQUIRED
Fig. 15
15