Product Specifications And Unpacking - Craftsman 315.212120 Owner's Manual

Blade Diameter
Blade Arbor
No Load Speed
Rating
Input
Net Weight
Your Compound Miter Saw has been shipped
completely assembled except for the blade, miter lock
handle, and dust guide.
WARNING:
If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
Remove all loose parts from the carton. Separate
and check with the list of loose parts. See Figure 2.
Remove the packing materials from around your
saw.
Carefully lift saw from the carton and place it on a
level work surface. This saw is heavy. To avoid
back injury, get help when needed.
PRODUCT SPECIFICATIONS
12 in.
1 in.
4000 RPM
120 Volts, 60 Hz-AC Only
15 Amperes
41 lbs.
UNPACKING
Cutting Capacity with Miter at 0°/Bevel 0°:
max width x resulting height
Maximum Cutting Capacity with Miter at 45°/Bevel 0°:
max width x resulting height
Maximum Cutting Capacity with Miter at 0°/Bevel 45°:
max width x resulting height
Do not discard the packing materials until you
have carefully inspected the saw, identified all
loose parts, and satisfactorily operated your new
saw.
Your saw has been shipped with the saw arm
locked in the down position. To release saw arm,
push down on top of saw arm and pull out the lock
pin. See Figure 4.
Hand pressure should remain on the saw arm to
prevent sudden rise upon release of the lock pin.
Examine all parts to make sure no breakage or
damage has occurred during shipping.
If any parts are damaged or missing, do not attempt to
plug in the power cord and turn the switch on until the
damaged or missing parts are obtained and are
installed correctly.
7
7-7/8 in. x 2-1/2 in.
5-1/2 in. x 2-1/2 in.
7-7/8 in. x 1-3/4 in.