Unpacking And Accessories - Craftsman 315.228510 Owner's Manual

Your new table saw has been designed to give you
many years of high quality performance. To insure
this goal, proper care and treatment is important.
Careful treatment begins with removing all parts from
the carton and checking them against the list of loose
parts. The long box contains the rails. The large box
holds all other parts, which are detailed in the Loose
Parts List.
Separate the saw and all parts from the packing
materials and check each against the packing list,
especially the small parts that can be hidden in the
packing material.
Note: Do not discard the packing materials until you
have carefully inspected the saw, identified all
parts, and satisfactorily operated your new saw.
WARNING:
Never use gasoline, naptha, or
other highly volatile solvents. Do not ever let
brake fluids, gasoline, petroleum-based
products, or penetrating oils contact plastic parts.
Such chemicals can weaken or destroy plastic.
The following recommended accessories are currently available at Sears Retail Stores.
• Fence Guide System
• Guide Master
• Box Joint & Miter Guide
• Universal Jig
• Taper Jig
• 10 in. Sanding Disc
• 8 in. Sanding Disc
• Elite Dado
• Excalibur Dado
WARNING:
UNPACKING
ACCESSORIES
The use of attachments or accessories not listed might be hazardous.
Remove the wax paper covering on the table. Use
any ordinary household type grease and spot
remover. Immediately apply a coat of automotive
type paste wax to the table and table exensions.
WARNING:
To prevent accidental starting that
could cause possible serious personal injury,
assemble all parts to your saw before connecting
it to power supply. Saw should never be
connected to power supply when you are
assembling parts, making adjustments, installing
or removing blades, or when not in use.
WARNING:
If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
• 7 in. Adj. Dado 36 tip
• 7 in. Adj. Dado 24 tip
• 7 in. Stack Steel Dado
• 7 in. x 9/16 in. Stack Dado
• 7 in. Molding Head Set
• 2 Bit Molding Head Set
• Saw Baskets
• Jointer Clamps
• Specialty Throat Plate
9
® TABLE SAW 315.228510