Locker Bracket Assembly; Tilt / Elevating Mechanism - Craftsman 10 IN. TABLE SAW 315.22811 Owner's Manual

This saw has been lubricated at the factory prior to
shipment. Following extended use, you should inspect
and lubricate the following areas to assure smooth
operation.
LOCKER BRACKET ASSEMBLY
See Figure 61.
• Add dry lube between both bevel gears, the
backup washers and the locker bracket.
• Add dry tube between threaded hole in motor
casting and threaded elevating shaft.
Recommended Lubricants:
Dry Silicone or Teflon Lubricant
TILT / ELEVATING MECHANISM
See Figure 62.
• Add dry lube between the handle shaft and the
bore of the clamping bolt.
• Add dry tube between the face of the clamping bolt
and the face of the handle shaft.
• Add dry lube on the inner surfaces of the bevel
locking lever which contacts the cam.
ELEVATING SHAFT
THREADED
HOLE
BEVEL GEAR
BACKUP
WASHER
CLAMPING BOLT
BRACKET
Figure 61
HANDLE
SHAFT
HANDWHEEL
ADAPTER
BEVEL
LOCKING LEVER
COMPRESSION
SPRING
BLADE
ADJUSTING HANDLE
Figure 62
CRRFTSHRN"TABLESAW315.228110 42