B. SETTINGS AND ADJUSTMENTS
TO REMOVE
THE BLADE
Use the two wrenches supplied with the saw for this
procedure
_l,
WARNING:
Unplug your saw and make sure
the blade guard assembly
is installed
and
working
properly
to avoid serious personal
injury.
•
Raise the blade guard. See figure 27, overview of
saw
•
Remove the three screws from the throat plate and
lift the throat plate out of the slot.
•
Push the bevel locking lever to the left for elevation
mode.
•
Raise the blade to its full height by turning the
blade adjusting handle clockwise.
•
Place the open end of the small hex wrench into
the slot beside the blade. The wrench will fit over
two flats on the arbor (blade shaft). See Figure 28.
•
Fit the large hex wrench onto the arbor nut. Turn
clockwise and remove the nut, taking care not to
drag your knuckles across the blade.
Note: The arbor nut has left-hand threads.
•
Remove the outer blade washer from the arbor and
then remove the blade. Make sure that inner blade
washer and both spacers are tight against arbor
shoulder.
•
Replace with a new blade. Make sure the blade
teeth are pointing forward, toward incoming work.
•
Put the outer blade washer and arbor nut back on,
aligning with the flats on the arbor. _ghten the nut
with a counterclockwise turn.
Note: Use care not to cross thread arbor nut. Do
not overtighten.
•
Rotate the blade by hand to make sure it is turning
freely.
•
Check the riving knife and adjust if needed (See
next procedure).
•
Insert the throat plate, lower the blade, then secure
the throat plate with the three throat plate screws.
Tighten the screws firmly.
•
Push bevel locking lever to the left to allow blade
elevation and lowering.
THROAT PLATE
BLADEGUARD
BEVEL
BLADE
LOCKING LEVER
ADJUSTING HANDLE
NOTE:PLACEBLADE BETWEEN
INNERANDOUTER BLADE WASHER
LARGE
RENCH
TO
LOOSEN
SMALL HEX
WRENCH
LARGESPACER
Figure 27
ARBOR
\
_h
ARBORNUT
TO ANGLEBLADE,
PUSHBEVELLOCKING
LEVERRIGHT,
_INNER
BLADE WASHER
OUTER
BLADEWASHER
,TO
TIGHTEN
Figure 28
TOLOWERBLADE, P USHBEVEL
LOCKING LEVERLIFTAND
ROTATE BLADEADJUSTING
HANDLE COUNTERCLOCKWISE
p#
#,l
TO RAISE BLADE, PUSH BEVEL
LOCKING LEVER LEFT AND
TO LOCK BLADE ANGLE,
ROTATE BLADE ADJUSTING
PUSH BEVEL LOCKING
HANDLE CLOCKWISE
LEVER LEFT
Figure 29
23
CRAFTSMAN"TABLESAW315.228110