Download Print this page

Xerox wc 5019 Service Manual page 15

Advertisement

Align the document and feed it correctly.
The image is defined at a low resolution. Adjust the resolution to a higher resolution . Granular see Insert document 6-
1. On page.
11-20 WorkCentre 5019/5021 User Manual ...
Customer Service Center. The contact number is printed on the machine attached to the machine. If a two-digit error
code (X-X) is displayed, you can pressing the ID card button will display a six-digit grouped error code (xxx-xxx).
WorkCentre 5019/5021 11-21 User Guide ... pg Start button. Press the STOP button to cancel the job. See the paper
load 4 to 7 times.
On the page. 11-22 WorkCentre 5019/5021 User Manual ... 153. 4-7. When you change the paper size and orientation,
first cancel the job by pressing the STOP button. See Adjusting the Paper Size in Stores 1 and 2 4-11. WorkCentre
5019/5021 11-23 User Guide ... 154. E-5: Paper Jam in Bypass 11-34. P. The left hood of the machine is open. Close the
blanket.
See machine components 3-1.
The front cover of the machine is open. Close the blanket. See machine components 3-1. 11-24 WorkCentre 5019/5021
User Manual ...
155. Tambour Cartridge Replacement 10-7.
When you reach the maximum copy limit, press the STOP button and contact until the limit is defined. AlsoThe drum
cartridge contains a spare drum cartridge. Ready.
091-441 Replace the drum cartridge soon. Prepare a spare drum cartridge. WorksCentre 5019/5021 11-27 User
Manager ... Page 158 Power up the machine, make sure the screen is blank and 117-327, then power up the machine. If
123-314 happened, an error occurred. The same message appears again, contact our customer service center. 11-28
Operation Guide 5019/5021 ... WARNING: If you must remove the tray to clear a paper jam, contact your local Xerox
representative. Do not remove the tray or it may injure you. If the paper is stuck around the joint unit, remove the latch.
Remove the jammed paper. Note Do not leave torn pieces of paper on the unit.
Return the latch to position.
11-30 WorksCentre 5019/5021 User Manager ... Page 161 If the paper is stuck in place of the chart, remove the jam by
lifting.
Press the center of the left cover, slowly close and lift the bypass. WorkCentre 5019/5021 11-31 User Manager ... gently
close one magazine motor cover. E-3: Paper jam in reservoir 1 in the reservoir and remove the paper jam in reservoir 1.
Remove the jammed paper using E-1: Krike Papos on the left cover and 11-30.
Page 11-32 WorksCentre 5019/5021 User Consumer Manager ... E-4: Paper overload in basket 2 based on this and
remove the paper jam in the bag. module in the reservoir. Package B 11-WorkCentre 5019/5021 11-33 User's Guide ...
E-5: Paper Jam on the Bypass Follow the steps below and clear the paper jam in the bypass. Remove the jammed paper
with the link to E-1: paper jam in the left cover and 11-30. Page 11-34 Corcentre 5019/5021 User Manager
WorksCentre ... page 165 If multiple sheets of paper are loaded, straighten the paper loop. Insert the paper with the
face, print and smooth it so that it slightly affects the van.Click Start. Use a computer to scan and restart the analysis.
WorkCentre 5019/5021 11-37 User Guide ... 168 Page Solution 11-38 WorkCentre 5019/5021 User Guide ... BAC 1
(Standard) and 2 (Optional): 60-90 GSM Mounder du Bac: 60-110 GSM note. Use paper recommended by Xerox.
Depending on the conditions, the copy may not be properly made. Document with the first copy of the document under
the glass: 7.5 seconds. Or less (A4 document feeder: 14 pp Paper NOTE: The machine may temporarily stop image
stabilization. Page 171 Monochrome: 600 × 600 DPI, 400 × 400 DPI, 300 × 300 DPI, 200 × 200 DPI. /MINUTE with
standard Xerox " document (A4) at 200dpi using Twain (USB) remote control: Digitizing speed varies depending on
documents WorkCentre 5019/5021 12-3 ... page Output height rectangle 95mm, 6.3kg (optional ) Identical size
paper/copy function paper weight 60 to 110 g/m2 Note: For paper weight 91 to 110 g/m2, use an optional power supply
such power supply ... The standard print area is less than 4.0 mm page area from top, pit, left and right side of paper
Actual print area may vary depending on printer (pointer) and control language Fault area print area/print area Power
supply warranty Paper power feel WorkCentre 5019/5021 12- 5" User Guide ...
This service is available when the reservoir module is installed. Notes • Optional components are subject to change
without notice. • Please contact our Customer Service Center for the latest information. 12-6 WorkCentre 5019/5021
User Guide ... Colors may appear faded at the bottom of high-density images when printing at low
temperatures.Information about a CD with a series of CDs with drivers, which are provided with the device. The
maximum scan of the page is 297 × 432 mm. For standard formats - A3 or 11 × 17 inches. WorkCentre 5019/5021 12-9
Users Management ... Page 178 Annex 12-10 WorkCentre 5019/5021 Manual Manual Manual Collection, 3-5 Document
collection device, 3-5 Original button, 3-11 Exposure Glass, 3 -2, 5-3, 6-4 left coverage, 3-3 guides, 3-5, 5 -3, 6-3
lighter/darker, 5-15 review of the document, 3-13, 6-3 workcend 5019/5021 User Guide ... Page 180 Drum Cartoon
Aardcase, 3-14 Empty paper tests, 3-14, 3-14 Error symbol, 3-14 types of paper, Source sifting area 4-1, 3-13 PDL, 12-3
3 3 areas of paper size, 3-14 Energy consumption, 12-3 Symbol of empty paper for paper, 3-14 connector of power
cables, 3-3 workcend 5019/5021 User Guide. 9- 3 Total copies View area, 3-13 tablet 1, 3-2 tablet 2, 3-2 tablets, 3-14
removal errors, twain driver 11-1, 12-4 USB interface, 2-2, 3- 3 button of the modification tube of the variable
downsizing, 3-11 heating time, User Guide 12-1 WorkCentre 5019/5021 .. Return Guide user manager WorkCentre
5019/5021 .... guide ...

Advertisement

loading