Advertisement
Available languages
Available languages
Important Installation
Information:
WARNING - ELECRICAL SHOCK HAZARD
•
Use extreme caution when drilling holes into the wall or floor. There
may be concealed electrical wires located behind the wall or under
the floor.
•
Identify the electrical circuits that could be affected by the installa-
tion of the Anti-Tip Device, then turn off power to these circuits.
•
Failure to follow these instructions may result in electrical shock or
other personal injury.
ATTENTION - PROPERTY DAMAGE
•
Contact a qualified installer or contractor to determine the proper
method for drilling holes through the wall or floor material (such as
ceramic tile, hardwood, etc.)
•
Do not slide the range across an unprotected floor.
•
Failure to follow these instructions may result in damage to wall or
floor coverings.
Tools Needed for Installation of Anti-Tip Device:
•
Screwdriver, Phillips
•
Drill, electric or hand
•
Measuring tape or ruler
•
1/8" drill bit (wood or metal wall or floor)
•
Hammer
•
Pencil or other marker
•
3/16" carbide-tipped masonry drill bit (concrete or concrete block wall or floor)
•
3/16" anchors, drywall or concrete, 4 each (not required if mounting bracket is
being attached to solid wood or metal)
For 30" and 36" Dual Fuel Ranges (Figure 6 and Figure 7)
Thermador Service
Part No.
415078
427338
•
The anti-tip bracket may be attached to a solid wood cabinet having a minimum
wall thickness of 3/4".
•
The thickness of the wall or floor may require use of longer screws, available at
your local hardware store.
•
In all cases, at least two (2) of the bracket mounting screws must be fastened to
solid wood or metal.
WARNING
•
All Ranges can tip
•
Injury to Persons could result
•
Install Anti-Tip Device Packed with
Range
•
See Installation Instructions
Qty
4
Screw, Phillips, #10 x 1-1/2"
1
Anti-Tip Bracket, Floor-Mounted
Description
Page 13
Advertisement
Chapters
