Download Print this page

Thermador PRD304EG Installation Manual page 12

Dual fuel ranges
Hide thumbs Also See for PRD304EG:

Advertisement

Available languages

Available languages

Gas and Electric Supply
Gas & Electrical Supply Locations for 30" and 36" Dual Fuel Ranges
Gas & Electrical Supply Locations for 48" Dual Fuel Ranges
Note: If not already present, install gas shut-off valve in an easily accessible location.
Make sure all users know where and how to shut off the gas supply to the range.
Note: The installer should inform the consumer of the location of the gas shut-off
valve.
Note: Any opening in the wall behind the appliance and any opening in the floor under the
appliance must be sealed.
The dual fuel ranges may be connected to the power supply with a range supply
cord kit or by hard-wiring to the power supply. It is the responsibility of the installer to
provide the proper wiring components (cord or conduit and wires) and complete the
electrical connection as dictated by local codes and ordinances, and/or the National
Electric Code. The units must be properly grounded. Refer to Step 6 for details.
Canadian models have power cord supplied.
The range must be connected only to the type of gas for which it is certified. If
the range is to be connected to propane gas, ensure that the propane gas supply
tank is equipped with its own high pressure regulator in addition to the pressure
regulator supplied with the range. (See Step 5.)
1 3/4" maximum protrusion
from wall for gas or
electrical supply
electrical
supply zone
supply zone
8 1/2"
6 "
6"
30 1/4" (30" models)
36 1/4" (36" models)
2" maximum protrusion
from wall for gas or
electrical supply
Location of hole for
Gas Supply Line
3"
4"
4"
Location of 240 VAC
Receptacle or Junction Box
48-1/4"
Figure 3a: Gas & Electrical Supply Locations for Dual Fuel Ranges
gas
1 3/4"
6"
6"
10"
2"
Page 9

Advertisement

loading