Installing The Heat Sink And Processor; Removing The Coin-Cell Battery - Dell OptiPlex 3010 Small Form Factor Owner's Manual

Installing The Heat Sink And Processor

1. Insert the processor into the processor socket. Ensure the processor is properly seated.
2. Lower the processor cover.
3. Press the release lever down and then move it inward to secure it with the retention hook.
4. Place the heat sink assembly into the chassis.
5. Tighten the captive screws to secure the heat-sink assembly to the system board.
6. Secure the Input/Output Board or the FlyWire cable to the routing channel on the heat sink.
7. Connect the heat sink assembly cable to the system board.
8. Install the drive cage.
9. Install the front bezel.
10. Install the cover.
11. Follow the procedures in
Related Links
Removing the Heat sink and Processor

Removing the Coin-Cell Battery

1. Follow the procedures in
2. Remove the cover.
3. Remove the front bezel.
4. Press the coin-cell battery inward to allow the battery to pop up from the socket.
5. Lift the coin-cell battery out of the computer.
Related Links
20
After Working Inside Your
Before Working Inside Your
Computer.
Computer.