Table of Contents
Advertisement
What to do next
Prepare the system for operation. For instructions, see "Preparing the 9006-12C system for operation after
you remove and replace internal parts" on page 80.
Removing and replacing PCIe adapters in the 9006-12C
Learn how to remove and replace Peripheral Component Interconnect (PCI) Express (PCIe) adapters in
the IBM Power System LC921 (9006-12C) system.
Removing a PCIe adapter from the 9006-12C system
Learn how to remove a PCIe adapter from the IBM Power System LC921 (9006-12C) system.
Before you begin
Power off the system and place it in the service position. For instructions, see "Preparing the 9006-12C
system to remove and replace internal parts" on page 78.
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap. The ESD wrist strap must be connected to an
unpainted metal surface until the service procedure is completed, and if applicable, until the service
access cover is replaced.
Attention:
v Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack, or to
an unpainted metal surface of your hardware to prevent the electrostatic discharge from damaging
your hardware.
v When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock when
using or working on electrical equipment.
v If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds. If at any point in this service process you move away from the system, it is important to
again discharge yourself by touching an unpainted metal surface for at least 5 seconds before you
continue with the service process.
2. An adapter can share a PCIe riser card with other adapters. Label and remove any cables and plugs
that extend out of the adapters. See Figure 32.
Figure 32. 9006-12C PCIe adapter positions
Position
1 (UIO Slot1)
A (UIO Network)
2 (WIO Slot1), 3 (WIO Slot2), 4 ( WIO-R Slot)
3. If you are working with a PCIe adapter in position 1, if the adapter has a special tailstock support,
unscrew the tailstock from the support. Remove the adapter from the PCIe riser.
Step
3
4 on page 32
5 on page 32
Removing and replacing parts in the 9006-12C
31
Advertisement
Table of Contents
