Table of Contents
Advertisement
8. Align the tool with the beveled edge (A) of the system processor module. Lower the tool over the
system processor module by ensuring the two guide pins (C) are inserted into the alignment holes
(B) on each side of the tool.
Figure 67. Lowering the removal tool onto the system processor module
9. With the removal tool (A) sitting on top of the system processor module, push down on the tool to
lock the system processor module into the tool as shown in Figure 68 on page 59.
The tool drops slightly when you push down on the processor module so that the jaws can grab the
bottom of the module. Make sure that both of the tool jaws are locked on the system processor
module. Do not press the blue release tabs until directed to do so later.
58
Power Systems: Servicing the IBM Power System LC921 (9006-12C)
Advertisement
Table of Contents
