Table of Contents
Advertisement
Chapter 7. Removing or replacing the appliance or parts
The Type 7199 appliance includes two of three types of replacement parts: Tier 1
customer replaceable unit (CRU) and field replaceable unit (FRU). However,
replacement parts for other IBM machine types can be any of the following types:
Tier 1 CRU
Tier 2 CRU
FRU
For information about the terms of warranty, see the IBM Statement of Limited
Warranty document that is provided with the appliance.
For information about obtaining service or assistance, see "Getting help and
technical assistance," on page 55.
Installation guidelines
Before you remove or replace a component, read the following information:
v Read "Handling static-sensitive devices" on page 36 and "Safety" on page v.
v Observe good housekeeping in the area where you are working. Place removed
v You do not have to disconnect the Type 7199 appliances from the power supply
v Ensure that you have an adequate number of properly grounded electrical
v Have a medium Phillips screwdriver available.
v Orange on a component indicates that the component can be hot-swapped. You
v Blue on a component indicates touch points, where you can grip the component
© Copyright IBM Corp. 2011
Replacement of a Tier 1 CRU is your responsibility. If an IBM
representative installs a Tier 1 CRU at your request, you will be charged
for the installation.
Replacement of a Tier 2 CRU can be installed by you or can be installed at
your request by an IBM representative for no charge if still under warranty.
If installed by an IBM representative after your warranty has expired, you
will be charged for the installation.
FRUs must be installed by trained service technicians only.
This information will help you work safely.
parts in a safe place.
to install or replace any hot-swap module.
outlets for the Type 7199 appliance.
can remove or install the component while the Type 7199 appliance is running.
Orange can also indicate touch points on hot-swap components. See the
instructions for removing or installing a specific hot-swap component for
additional procedures that you might have to perform before you remove or
install the component.
to remove it from or install it in the Type 7199 appliance, open or close a latch,
and so forth.
35
Advertisement
Table of Contents
Troubleshooting
