Table of Contents
Advertisement
Figure 4. Removing the 2.5-inch drive from the tray
7. If you are removing more than one drive, repeat the steps in this procedure until all drives are
removed.
Replacing a front disk drive in the 9006-12C or 9006-22C system
Learn how to replace a disk drive in the front of the IBM Power System LC921 (9006-12C) or IBM Power
System LC922 (9006-22C) systems.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Install a drive into the tray. Orient the drive such that the connectors are pointing to the rear of the
drive.
v A 3.5-inch drive fills the tray, as shown in Figure 5 on page 7. Fasten the drive to the sides of the
tray with four screws (two screws on each side).
6
Power Systems: Servicing the IBM Power System LC921 (9006-12C)
Advertisement
Table of Contents
