Stand-Alone Mode; Interconnecting Several Devices (Master/Slave Operation) - EuroLite LED PIX-72 User Manual

Stand-alone mode

Interconnecting several devices (master/slave operation)

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
Slnd is indicated on the display. Confirm with the ENTER button. You can then select between SL1 or
SL2. Confirm with the ENTER button.
2 To determine the master device press the MENU button until the menu item MASt appears in the
display. Confirm with the ENTER button.
3 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
4 Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.
Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1 Press the MENU button so many times until Soun is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with the ENTER
button.
2 Now use the buttons UP and DOWN to adjust the microphone sensitivity to the volume of the music
(Se00 = low, Se99 = high).
3 If you enable the silent scene mode in menu item SInd, the LEDs will be switched off if the volume is too
low or if there is no sufficient bass beat. If you disable this mode the LEDs remain switched on during
periods without music.
Automatic mode
In automatic mode, 16 show programs are available that run at an adjustable speed.
1 Press the MENU button so many times until Auto is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with ENTER again.
2 Now use the buttons UP and DOWN to adjust the running speed of the program from SP0 (slow) to SP9
(fast). Confirm with ENTER.
Individual color mix
In the color mode CoLo each of the LEDs can be individually adjusted for brightness. The device will
constantly emit the adjusted color.
1 Press the MENU so many times until CoLo is indicated in the display. Confirm with the ENTER button.
2 Now the display indicates red for the color red and the corresponding brightness value. Use the buttons
UP and DOWN to adjust the desired brightness.
3 Confirm with the ENTER button. Now the color green can be adjusted, then blue.
Display reverse
To invert the display by 180°, press the MENU button so many times until dISP is indicated in the display.
Confirm with the ENTER button. The display shows dSIP. Each time you press the ENTER button, the
display rotates.
Indicate software version
To indicate the version number of the firmware (operating system of the unit), press the button MENU so
many times until Ver is indicated in the display. Confirm with the ENTER button. The version will be indicated
in the display.
24/28 00135837, Version 1.0