Lenze smd401 Operating Instructions Manual page 19

Code
No. Name
Frequency setpoint
via keys
or Modbus
Start condition
(with mains on)
Mode selection for c61
Present status/error
Last error
Last error but one
7
Configuration TRIP
reset (error reset)
7
Auto-TRIP reset delay
7
Operating time
counter
7
Mains connection
time counter
PI setpoint
S-ramp integration
time
Minimum feedback
Maximum feedback
d
PI setpoint accel/
decel
d
PI mode
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Possible Settings
Lenze Selection
0.0 0.0 {Hz}
1 0 Start after LOW-HIGH change at
terminal 28
1 Auto start if terminal 28 = HIGH
WARNING!
Automatic starting/restarting may cause damage to equipment and/or injury to
personnel! Automatic starting/restarting should only be used on equipment that is
inaccessible to personnel.
0 0 Monitoring only
1 Monitoring and editing
status/error message
error message
0 0 TRIP reset after LOW-HIGH
change at terminal 28, mains
switching, or after LOW-HIGH
change at digital input "TRIP reset"
1 Auto-TRIP reset
WARNING!
Automatic starting/restarting may cause damage to equipment and/or injury to
personnel! Automatic starting/restarting should only be used on equipment that is
inaccessible to personnel.
0.0 0.0 {s}
Display
Total time in status "Start"
Display
Total time of mains = on
0.0 c86
0.0 0.0 {s}
0.0 0.0
100 0.0
5.0 0.0 {s}
0 0 PI disabled
1 PI enabled: normal-acting
2 PI enabled: reverse-acting
ENGLISH
Commissioning
500 Only active if C01 is set properly
(C01 = 1,5,7,9,11)
See also c70
c60 = 1 allows the keys
speed setpoint (c40) while monitoring c61
• Display
• Refer to Section 5 for explanation of
status and error messages
• Auto-TRIP reset after the time set in
c71
• More than 8 errors in 10 minutes will
trigger
60.0 See c70
0...999 h: format xxx
1000...9999 h: format x.xx (x1000)
10000...99999 h: format xx.x (x1000)
c87
50.0 • c82 = 0.0: Linear accel/decel ramp
• c82 > 0.0: Adjusts S-ramp curve for
smoother ramp
999 • Select feedback signal at C34
• If feedback is reverse-acting, set
999
c86>c87
999 Sets rate of change for PI setpoint
When feedback (terminal 8) exceeds
setpoint, speed decreases
When feedback (terminal 8) exceeds
setpoint, speed increases
IMPORTANT
to adjust
fault
17