Grounding Generator To Truck Or Trailer Frame; Using Lifting Eye - Miller Big 40 C Owner's Manual

5-4. Grounding Generator To Truck Or Trailer Frame

5-5. Using Lifting Eye

1 2
GND/PE
3
3
!
Always ground generator
frame to vehicle frame to pre-
vent electric shock and static
electricity hazards.
!
Also see AWS Safety &
Health Fact Sheet No. 29,
Grounding of Portable And
Vehicle Mounted Welding
Generators.
!
Bed liners, shipping skids,
and some running gear insu-
late the welding generator
from the vehicle frame. Al-
ways connect a ground wire
from the generator equip-
ment grounding terminal to
bare metal on the vehicle
frame as shown.
!
If unit does not have GFCI re-
ceptacles, use GFCI-pro-
tected extension cord.
1 Equipment Grounding
Terminal (On Front Panel)
2 Grounding Cable (Not
Supplied)
3 Metal Vehicle Frame
Connect cable from equipment
ground terminal to metal vehicle
frame. Use #8 AWG or larger insu-
lated copper wire.
.
Electrically bond generator
frame to vehicle frame by met-
al-to-metal contact.
1 Lifting Eye
2 Nut
3 Carriage Bolt
1
Raise lifting eye until it snaps in
place. Lower lifting eye when not
needed.
To lock the lifting eye in the upright
position, insert a 3/8-16 x 1-1/2 in.
carriage bolt through slot in bracket
2
and secure with nut (bolt and nut not
supplied).
rot_grnd1 2010−04 − 800 652-D
Tools Needed:
Lift1 2008−01 804 712
OM-4427 Page 25