1-1. Grounding Generator To Truck Or Trailer Frame; Installing Exhaust Pipe - Miller Bobcat 260 Owner's Manual

5-2. Grounding Generator to Truck or Trailer Frame

1-1. Grounding Generator To Truck Or Trailer Frame

Always ground generator frame to
vehicle frame to prevent electric
shock and static electricity hazards.
Also see AWS Safety & Health Fact
Sheet No. 29, Grounding of Portable
And Vehicle
Generators.
5-3.

Installing Exhaust Pipe

1/2 in.
wrench
crescent wrench
nutdriver
�
Complete Parts List is available at www.MillerWelds.com
Bed liners, shipping skids, and
some running gear insulate the
welding generator from the vehicle
frame. Always connect a ground
wire from the generator equipment
grounding terminal to bare metal on
Mounted Welding
the vehicle frame as shown.
1 Equipment
Front Panel)
Complete Parts List available at www.MillerWelds.com 2 Grounding Cable (Not Supplied)
1 2
GND/PE
3
Grounding Terminal (On
253857-A
3 Metal Vehicle Frame
Connect cable from equipment ground ter-
minal to metal vehicle frame. Use #8 AWG
or larger insulated copper wire.
�
Electrically bond generator frame to
vehicle frame by metal-to-metal
contact.
Stop engine and let cool.
Engine backfire can cause severe
burns or other injuries. Do not
point exhaust pipe toward control
panel. Keep away from exhaust
outlet.
Do not point exhaust pipe toward
LP fuel tank (if equipped). Do not
point exhaust pipe towards shield-
ing gas tank (if equipped).
Point exhaust pipe in desired di-
rection but always away from front
panel and direction of travel.
OM-286504 Page 23