QuickJack 3500SLX Setup And Operation Manual page 9

• One Power Unit (includes Pendant Control). Not shown. Provides power to the QuickJack
Frames. There are three Power Units available: 110 VAC, 220/240 VAC, CE-approved 220 VAC.
CE/UKCA approved Power Units part numbers 5585360 / 5585760 / 5585739.
• Parts Bag. Holds the components used during setup; includes the Hydraulic Fittings.
• Two Power Unit Quick-Connect Fittings. One end connects to the Long Hydraulic Hose,
while the other end connects to a Hydraulic Port on the Power Unit.
• Two Male Quick-Connect Fittings. One end connects to the Short Hydraulic Hose, and the
other end connects to the Long Hydraulic Hose.
• Four Female Quick-Connect Fittings. One goes on each end of the Long Hydraulic Hose.
Two per each Long Hydraulic Hose.
• Two Short Hydraulic Hoses. Connect one end to the Hydraulic Cylinder on each Frame and
on the other end to one of the Long Hydraulic Hoses. Note that the Short Hydraulic Hoses must
be routed under the bottom of the Frame, never over the Frame.
• Two Long Hydraulic Hoses. Connect one end to the Power Unit and on the other end to one
of the Short Hydraulic Hoses.
Tip
• Two Frame Positioning Handles. Used to easily move the QuickJack Frames, usually to
position the Frames under the Vehicle's factory-recommended Lifting Points.
• Lock Bars. The two Lock Bars, one on each QuickJack Frame, hold the Frames in position when
they are raised.
Only leave the QuickJack either fully lowered or engaged on a Locking Position.
• Hydraulic Cylinder and Auxiliary Pneumatic Spring. Each QuickJack Frame has one
Hydraulic Cylinder and one Pneumatic Spring. The Hydraulic Cylinder receives Hydraulic Fluid from
the Power Unit, which is used to move the Frames up and down. The Pneumatic Spring acts like a
spring to assist in lowering the Frames.
• Wheels. The two Wheels on the non-sticker end of each QuickJack Frame allow you to easily
move the Frame to a different location. Note that the Wheels and the weight of the Frame can
leave marks on some floors, so be careful using them.
• Handles. On the sticker end of each QuickJack Frame is an opening that can be used as a
Handle when you are moving the Frame. To pick up a Frame by its Handle, with one hand raise the
Frame just off the ground under the large yellow sticker, then put the other hand in the Handle and
continue to raise the Frame.
⚠
DANGER
QuickJack™ Portable Car Jack
To move your QuickJack components: disconnect the Long Hydraulic Hoses either
at the Power Unit or at the Short Hydraulic Hoses. This is easier than trying to move
the QuickJack with all components connected.
Pinch and crush hazard! Keep clear of the QuickJack mechanism as it lowers.
Be careful not to pinch or crush your fingers when lowering the Frame to the
ground.
9
P/N 5900263 — Rev. B6 —September 2023