QuickJack 3500SLX Setup And Operation Manual page 4

The QuickJack is designed and engineered to be used with the weight of a Vehicle on it. You
should only raise the QuickJack Frames with the weight of a Vehicle on them, even the very
first time you use them (with the exception of bleeding the Hydraulic Cylinders). There is
simply no reason to raise your QuickJack Frames unless there is a Vehicle on them.
Why are we telling you to do it this way? Because your QuickJack Frames may occasionally
become stuck up in the air if you raise them without the weight of a Vehicle. There is nothing
wrong with them if this happens, and the issue can be quickly and easily fixed, it is just that
they are designed and engineered to work with the weight of a Vehicle. Only raise your
QuickJack Frames with a Vehicle on them.
A
nd since we have your attention...
Do remove your Vehicle's tires then lower the QuickJack to the ground.
not
The QuickJack requires space between the ground and your Vehicle to build up enough force
to raise a Vehicle. It cannot raise a full load from a completely flat starting position.
This is not a problem in normal operation, as the Vehicles you want to raise are being held well
above the ground by their tires. The problem generally happens when people lower the
QuickJack to a completely flat position with the Vehicle's tires removed.
What do you do if either of these problems happens to you? Refer to Troubleshooting.
QuickJack™ Portable Car Jack
Only raise your QuickJack Frames
with a Vehicle on them!
I
MPORTANT
P
LEASE
4
P/N 5900263 — Rev. B6 —September 2023
!
R
EAD
Do
Not
Do
This!