QuickJack 3500SLX Setup And Operation Manual page 41

⚠
CAUTION
2. Move the QuickJack Frames to the appropriate locations, based on positioning method.
3. Drive the Vehicle over the Frames if you are using the Inside out method.
Only raise your QuickJack with a Vehicle on it.
4. Move the QuickJack Frames to the correct locations under the Vehicle based on the factory-
recommended Lifting Points.
⚠
WARNING
5. Adjust the Lift Blocks in the Receiver Trays so that they are directly underneath the factory-
recommended Lifting Points for the Vehicle you are raising.
6. Check both Lock Bars; raise them up and let them drop to confirm freedom of motion.
Not to scale. Components removed for clarity. Left side shows Lock Bar moving freely in Lock
Channel, right side shows Lock Bar stuck in the air, which must be corrected.
If the Lock Bar Bolt is too tight, it does not allow the Lock Bar to move freely in the Lock Channel.
This is a safety issue; the QuickJack locks cannot be engaged unless each Lock Bar is
moving freely in its Lock Channel. If the Lock Bar moves up with the Vehicle as it is raised (as
shown above on the right), it cannot lock.
⚠
WARNING
To fix an overtightened Lock Bar Bolt, loosen the Lock Bar Bolt until the Lock Bar moves freely and
stays in the Lock Channel (as shown above, on the left).
7. Walk around the Vehicle and the QuickJack Frames; make sure everything is set up correctly.
8. Connect the hydraulic hoses to the frames and the Power Unit.
9. Connect the power unit to power.
10. Press and hold Up on the Pendant Control.
11. Just before the Frames contact the Vehicle, release Up. The Frames stop moving.
QuickJack™ Portable Car Jack
Do not raise any load on the Frames alone; always use Lift Blocks, Pinch-Weld
Blocks, or the SUV and Light Truck Adapters in the Receiver Trays.
If you do not know the factory-recommended Lifting Points for the Vehicle you are
raising, consult Vehicle Lifting Points for Frame-Engaging Lift and SAE Standard
J2184, Vehicle Lift Points for Service Garage Lifting, as a resource to assist you in
the proper positioning of a Vehicle for raising (these documents are available on the
ALI website). If the Vehicle has an additional or uniquely positioned payload, have
a qualified person calculate the Vehicle center of gravity or have the Vehicle center
of gravity determined at a Vehicle scale.
The Lock Bar must be moving freely in the Lock Channel. If it is not, the QuickJack
cannot be put into a safe, locked position.
41
P/N 5900263 — Rev. B6 —September 2023