Setup - QuickJack 3500SLX Setup And Operation Manual

Setup

This section describes how to set up your QuickJack.
⚠
WARNING
Your QuickJack is supplied with setup instructions that meet the criteria set by the latest version of the
American National Standard "Automotive Lifts – Safety Requirements for Construction, Testing, and
Validation" ANSI/ALI ALCTV.
Setup
Setup Safety Rules
1
Checklist
When setting up a QuickJack, your safety depends on proper training and thoughtful operation.
⚠
WARNING
BendPak recommends referring to the ANSI/ALI ALIS Standard (Current Version) Safety Requirements
for Installation and Service for more information about safely setting up, using, and servicing your
QuickJack.
Always pay attention during setup. Use appropriate tools and equipment. Stay
clear of moving parts. Keep hands and fingers away from pinch points.
⚠
WARNING
Setup
Tools
2
Checklist
You need the following tools to set up your QuickJack:
• Metric and SAE hex key set
• Metric and SAE socket and ratchet sets
• Metric and SAE Combination wrench set
• 8 or 10-inch Adjustable wrench
• Screwdriver set
Tip
At some point during setup, you will need to provide some air pressure (up to 50 psi, for the
Pneumatic Springs) and 2.1 quarts / 2 liters of Hydraulic Fluid.
QuickJack™ Portable Car Jack
Use only the factory-supplied parts that came with your QuickJack. If
you use any attachments, accessories, or configuration modifying components that
are located in the load path and/or affect operation of the Lift, affect the Lift's
electrical listing, or affect the intended Vehicle accommodation, and if they are not
certified for use with this Lift, then you void the warranty of your QuickJack as well
as compromising the safety of everyone who sets up or uses the Lift. If you are
missing parts, visit
Support at support@quickjack.com, or call (888) 262-3880 or
(805) 933-9970.
Always use proper tools, such as a forklift or shop crane, to move heavy
components. Do not install this equipment without reading and understanding this
manual and the labels on the unit.
You must always wear protective equipment during setup: leather
gloves, steel-toed work boots, eye protection, back belts, and hearing protection.
Keep a rag handy during setup to clean Hydraulic Fluid spills or leaks.
quickjack.com/support
15
or contact QuickJack Technical
P/N 5900263 — Rev. B6 —September 2023