Periodical Service Points - Villager VGS 620 S Original Instruction Manual

Gasoline chain saw

Table of Contents

Available languages

Villager

Grease the nose sprocket from the feeding port on the tip of the bar. (F28)

(1)

(2)

Oiling port;

(1) Screen

(2) Clip

(3) Filter

(3)

Grease port;

Sprocket.

4. Others

Check for fuel leakage and loose fastenings and

damage to major parts, especially handle joints and

guide bar mounting. If any defects are found, make

sure to have them repaired before operation again.

■ PERIODICAL SERVICE POINTS

1. Cylinder fins

Dust clogging between the cylinder fins will cause

overheating of the engine. Periodically check and

clean the cylinder fins after removing the air cleaner

and the cylinder cover. When installing the cylinder

cover, make sure that switch wires and grommets

are positioned correctly in place. (F29)

Be sure to block the air intake hole.

2. Fuel filter

(a) Using a wire hook, take out the filter from the

filler port. (F30)

(b) Disassemble the filter and wash with gasoline, or

replace with new one if needed. (31)

(4) Sleeve

(5) Retainer

VGS 620 S (GB)

Table of Contents