Installing Guide Bar And Saw Chain - Villager VGS 620 S Original Instruction Manual

Villager

5. INSTALLING GUIDE BAR AND SAW CHAIN

up (12-15Nm). Then check the chain for smooth rotation and proper tension while
moving it by hand. If necessary, readjust with the chain cover loose.
The saw chain has very sharp edges. Use thick
protective gloves for safety.
1. Loosen the nuts and remove the chain
cover.(F1)
2. Fit the saw chain around the guide bar and,
while gearing the chain to the sprocket, mount the
guide bar to the power unit. Then fit the chain
tensioner nut into the lower hole of the guide bar.
(F1)
(1) Chain cover
(2) Chain tensioner nut
Pay attention to the correct direction of the saw
chain. (F2)
(1) Moving Direction
3. Fit the chain cover to the power unit and fasten
the nuts to finger tightness.
4. While holding up the tip of the bar, adjust the
chain tension by turning the tensioner screw until
the tie straps just touch the bottom side of the bar
rail. (F3)
5. Tighten the nuts securely with the bar tip held
VGS 620 S (GB)
13