Huawei LUNA2000-97KWH-1H1 Quick Manual page 45

9
Commissioning (SmartLogger WebUI)
•
The operating system of Windows 7 or later is supported.
•
The web software version corresponding to the WebUI screenshots in this guide is
SmartLogger V300R023C00SPC153. The screenshots are for reference only.
• For details about deployment commissioning in energy storage scenarios, see the
Commercial and Industrial Microgrid Energy Storage Solution Quick Guide
9.1 Preparations and WebUI Login
1. Connect the network cable between the PC network port and the SmartLogger.
2. Set the IP address of the PC. Ensure that the IP address is in the same subnet as that of the
SmartLogger.
Port IP Setting
IP address
SmartLogger
Subnet mask
WAN port
Default gateway
IP address
SmartLogger
Subnet mask
LAN port
Default gateway
• When the IP address of the WAN port is in the network segment from 192.168.8.1 to
192.168.8.255, set the default gateway to 192.168.8.1 and the IP address of the LAN port to
192.168.3.10. If the connected port is a LAN port, you need to adjust the network
configuration of the PC.
•
It is recommended that the PC be connected to the LAN port of the SmartLogger or the GE
port of the SmartModule. When the PC is connected to the GE port of the SmartModule,
adjust the network configuration of the PC in the same way as when the PC is connected to
the LAN port of the SmartLogger.
3. Set LAN parameters.
•
If the SmartLogger is connected to
a LAN and a proxy server has been
configured, you need to disable
the proxy service.
• If the SmartLogger is connected to
the Internet and the PC is
connected to the LAN, do not
disable the proxy service.
a. Open Internet Explorer.
b. Choose Tools > Internet Options.
c. Click the Connections tab and click
LAN Settings.
d. Clear Use a proxy server for your LAN.
e. Click OK.
Default Value on SmartLogger
192.168.0.10
255.255.255.0
192.168.0.1
192.168.8.10
255.255.255.0
192.168.8.1
44
.
Example PC Setting
192.168.0.11
255.255.255.0
192.168.0.1
192.168.8.11
255.255.255.0
192.168.8.1