5.4
Installing the Rack Controller
1. Remove the decorative cover and maintenance compartment cover from the rack controller
using the delivered security Torx wrench.
2. Install short-circuiting copper bars that are delivered with the product.
•
Secure the copper bars using a 16 mm socket.
•
When installing a nut, manually insert the nut into the screw plate, and then use a socket
wrench to completely secure the nut in place. This prevents the screw thread from being
stuck or stripped due to the deviation of the nut position.
•
Preinstall nuts according to the recommended torque of 21 N· m.
•
Verify the torque of the installed nuts using a torque socket wrench set to 21 N· m.
•
Mark the nuts whose torque has been verified using a marker.
200 kWh Model
18