Normalize Edit Op Improvements; Changes Made To The Sequencer In V 1.50; The Sx-1 Now Supports Piano Roll Note Event Dragging - Tascam SX-1 Release Note

27. NORMALIZE edit OP improvements

In V1.50, the Normalize Edit OP has the following improvements:
1. Direct entry of max dB value instead of fader
2. During normalizing phase, the amount of gain being added is displayed
3. Peak detection mode. Enable the Peak Detection button and execute the effect.
Instead of performing the normalize, the progress bar completes the peak detection phase and
displays the maximum signal level detected. It will not continue to the normalize phase.

Changes made to the sequencer in V 1.50

1.

The SX-1 now supports Piano Roll Note event dragging

The SX-1 now supports the dragging of individual notes on the Piano Roll. It is thus now possible to
drag/copy existing MIDI notes to other locations on the timeline.
Select some notes using the Event selector tool. Hold down the Microsoft key (in between the Control
and Alt keys on your PS/2 keyboard) and drag the notes around.
The notes above were drag-copied after being selected with the Event tool.
NOTE: It is also possible to add to a selection by holding down the SHIFT key while clicking and
dragging.
ADDITIONAL NOTE: When the selected notes are dragged in time or pitch, those notes will be˚sent
out of the MIDI port as well, unless the MIDI AUDITION setting is turned off. MIDI AUDITION is
located on the VGA Track screen Global Tab or the LCD MISC Preferences screen.
45