Even More Feedback Of The Transport State; User Bank 3 Default Changed; Loop Mode Additions; Transport Nudge Feature Added - Tascam SX-1 Release Note

8.

Even more feedback of the transport state

In such an event as the SX-1 performs a re-chase, an entry will be made in the error log. Selecting the
error log from either the VGA or LCD screen will display this information, as the log will not pop up.
9.

User Bank 3 default changed

The default setting for user bank 3 has been changed, which will be viewable if you create a new
project.
The new assignments are:
Fader 1-8: Buss Master 1-8
Fader 9-16: Group Master 1-8

10. Loop mode additions

The operation of Loop Mode has been enhanced to include two additional options. The three options
are:
1. Loop repeatedly. This was the only option for version 1.0.
2. Loop once and cue. This mode plays through the loop once and locates to the loop start point.
3. Loop once and stop. This mode plays through the loop once and stops at the loop end point.
Loop mode is operated in the same manner as it was pre-V1.5.
The new options can be chosen on the LCD Preferences Screen.

11. Transport Nudge Feature added

The front panel key combination of Shift+REW or Shift+FFWD will cause the transport to locate by
the amount currently specified by the EDIT NUDGE setting.

12. HDR Rec Arms now follow channel routing

From V1.50, more intelligence has been added to the mapping of the rec-arm buttons to the HDR
tracks.
Prior to V1.50, the LCD Transport External devices screen was used to assign a block of 16
consecutive mixer channel rec-arm buttons to the HDR tracks. If the routing were used to break the
consistency of the order of HDR tracks and mixer channels, the rec-arms would become confusing.
From V1.50, a now option, labeled auto in the transport channel assign menu is available. When
this option is selected, the rec-arm buttons will automatically follow the assignment of HDR output
channels to anywhere on the mixer s input channels, including multiple routings.
When a V1.00 or V1.10 project is first loaded into V1.50, if the default routing is in effect, and the
transport HDR channel assignment is still default (CH17), then the setting will be converted from
CH17 to auto , so that the automatic channel follow logic is enabled.
25