Muse M-1915 DJ - Trolley Perty Bluetooth Speaker Manual

Please read the instruction carefully before operating the unit.

LOCATION AND DESCRIPTION OF CONTROLS

MAIN UNIT

1. MIC. 1 Jack
2. MIC. 2 Jack
3. AUX IN Jack
4. USB CHARGING port
5. USB MP3 port
6. REPEAT button
7. PREV / (Previous) button
8. (Play/Pause) button
9. NEXT / (Next) button
10. MUTE button
11. MIC. FIRST button
12. Front light mode button
13. Speaker light mode button
14. MIC. ECHO knob
15. MIC. VOL knob
16. MEGA BASS button
17. / M (Standby&Power on / Mode) button
18. TONE button
19. EQ button
20. VOL knob
21. Display
22. Front color light
23. Speaker
24. DC IN jack
25. Power On/Off Switch

ACCESSORIES

AC adaptor x 1
Wired microphone x 1

POWER SUPPLY

Using the AC adaptor

Insert the small end of the AC adapter into the DC IN 15V jack on the rear of the unit. Insert the other end (with the 2 blades) into a conveniently located AC outlet having 100-240V AC, 50/60Hz.

• The AC adaptor included with this unit is for its use only. Do not use it with other equipment.
• Turn off the unit before unplugging the AC adaptor from the unit so as to avoid the unit being damaged.
• When the unit is not going to be used for long time, disconnect the AC adaptor from the AC outlet.
• Be sure to use it near the wall outlet and easily accessible. If a malfunction occurs, disconnect the plug from the wall outlet at once.
• AC adaptor is used as the disconnect device. It shall remain readily operable and should not be obstructed during intended use. To be completely disconnected the apparatus from supply mains, the AC adaptor of the apparatus shall be disconnected from the mains socket outlet completely.
• Never use an AC adaptor that is damaged, route power lead in a safe manner and make sure it is not subjected to trapping or pinching. If the power lead is damaged refer to a qualified service agent.

Using the Built-in Battery

The unit is powered by a built-in lead-acid rechargeable battery. Charge the built-in battery for at least four hours before using the device for the first time.
To charge the internal battery, Connect the AC adapter to the DC IN 15V jack of the unit and to the mains socket. The function LED indicator will light solid red during charging and light off when the battery becomes fully charged.

• While using the built-in battery, the environmental temperature should be 5°C (41°F) to 35°C (95°F).
• The built-in battery in this device may present a risk of fire or chemical burn if mistreated. Do not disassemble, heat above 100°C (212°F), or incinerate.
• To get the longest service life of the built-in battery, charge at indoor-temperature.
• Attention should be drawn to the environmental aspects of battery disposal.
• Do not throw batteries in fire!
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• The unit will switch to standby mode automatically when the battery is too low to work.

GENERAL OPERATION

1. Connect the AC adaptor to the unit and wall outlet, press the Power ON/OFF switch to turn on the unit, and the display will light up. Press and hold / M button to enter standby mode.
2. Press the / M button repeatedly to switch to desired mode:
   Bluetooth / FM / AUX / USB
   Note: Only insert USB driver could switch into USB mode.
3. During Playback:
   • Adjust the VOL knob to select the volume level as desired.
   • Press the EQ button to set EQ (equalizers) mode as desired:
     FLAT(normal)/ CLAS (classic)/ rOC(rock)/ POP/ JAZZ/ LIVE/ CLUB/ DANC(dance)/ HALL/ SOFT
   • Press button to play or pause.
   • Press MUTE button to mute the sound. Press again to resume.
   • Press the button to skip to the next track. Press the button to skip to the previous track.
     Note:
     • REPEAT function only work in USB mode.
     • MEGA BASS: It is a separated bass mode can be selected when there is audio signal.
     • TONE: When there is audio signal, press this button to select treble or bass effect, then rotate the VOL knob to adjust the level as desired.
4. When finished listening, press the Power ON/OFF switch to turn off the unit.
   Note: If no source is played in Bluetooth & USB mode, the unit will go to standby mode automatically after 10 minutes. When you turn on the unit again, it will enter Bluetooth mode directly, and the volume will be restored to level 15.

LISTENING TO THE RADIO

Manual search

1. When the unit is on, press / M button repeatedly until the FM frequency appears on the display.
2. Press and hold / for step forward/rewind to search located station automatically until one station is founded, then unit will stop to search.

Automatic search and storage

Press and hold the button, the automatic search located strong station, and the unit will save the first 20 FM stations automatically. Long press the button again to stop the operation. When you store on a channel already been preset, the previous station will automatically be cleared and replaced by the new station. Note: During the search operation, the sound level is automatically muted.

Preset stations

This unit can store 20 FM stations.

Listen to station presets

1. Press / repeat the operation as many times as necessary to select the desired station.
2. Adjust the volume by VOL knob to the desired level.

USB PLAYBACK

You can connect a USB flash drive (not included) to the USB port on the unit to play MP3 files.

1. Insert USB driver, the unit will read USB driver and play music automatically as "USB" appear on display.
2. Press to suspend momentarily the playing track. Press again to resume playing.
3. Press button to skip to next track and to skip to previous track.
4. Press REPEAT button to select to repeat current track or repeat all tracks.

Note:

• The unit will automatically switch to USB mode and start playback when the USB flash drive is connected.
• The unit is compatible with the following Memory Device (Source): USB flash drive.
• Supporting format: MP3 (32kbps-320kbps), WMA, WAV.
• The total number of MP3 files on the Memory Device should not exceed 9999.
• There are many USB devices in the market. We cannot guarantee to support all different models. Please try another USB device if your device is not supported.

LISTENING TO AUXILIARY SOURCE

1. Connect your auxiliary source (e. g. iPod / iPad / MP3 player) to the AUX IN jack (3.5mm).
2. When the unit is on, press the / M button repeatedly until the "AUH" appears on display.
3. Start playback from your auxiliary source.
4. Adjust the volume to desired level.
5. To stop playback, disconnect your auxiliary source from the AUX jack.

Note: Button / / are not available in Aux in mode, only could control via external connected device.

USB CHARGER- A POWER USB PORT

Connect your device to USB cable (not included) and plug the standard USB plug into the USB charging port on the top of the unit.

Note:

• The maximum output from the USB charging port is DC 5V 1A. You can charge any rechargeable USB devices charging current less than it, such as smartphone, tablet...etc.
• Charging function is not available in Standby mode.
• Some devices may be incompatible.

BLUETOOTH PAIRING & LINKING OPERATION

The Bluetooth^® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by New One S.A.S is under license. Other trademarks and trade names are those of their respective owners.

1. Turn off the Bluetooth functionality of other devices that were paired with your unit.
2. When the unit is on, press / M button repeatedly until "bt" appears on display.
3. On the Bluetooth device, enable Bluetooth and select "M-1915 DJ" from the Device List. (Refer to the user manual of the device to be connected for detailed operations.) If the Bluetooth device prompts for a passcode, use "0000". Some Bluetooth devices will ask you to accept the connection. If the units are paired properly, you will hear the sound "Connected".

Tip: If you want to connect your Bluetooth speaker to another Bluetooth audio device, press and hold the button to disconnect the device, and then follow the steps above to make a new connection.

Hereby, NEW ONE S.A.S, declares that this MUSE M-1915 DJ is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity may be consulted at www.muse-europe.com

Play MUSIC from Bluetooth devices

Make sure the Bluetooth connection between the unit and the device is active.

1. Press to suspend momentarily the playing track. Press again to resume playing.
2. Press button to skip forward to next track and to skip backward to previous track.

Note: / / buttons may not work with some of the players in your Bluetooth source.

SINGING THROUGH MIC JACK

1. Sing along with the music by plugging in the provided microphone into either one of the MIC (1 / 2) jacks on the unit. Rotate the MIC. VOL directly to adjust the volume as desired.
2. MIC. FIRST: Press this button to make the mic.volume louder than the music volume during singing. Press the button again to resume.
3. MIC. ECHO: Rotate this knob directly to adjust the echo intension.

Notes:

• If the microphone is placed near the loudspeaker, a howling effect (acoustic feedback) may occur. If this happens, place microphone away from the loudspeaker.
• Tapping or dropping the microphone can permanently damage your microphone. Resist the urge to swing the microphone around by the cord.

CHOOSING THE LED LIGHT MODE

To select the front light mode & speaker light mode, press the / button repeatedly to choose the mode as desired, there are 8 kinds of modes on front light and 9 kinds of modes on speaker light. Press and hold the / button to turn off the light.

TROUBLESHOOTING GUIDE

• The apparatus shall not be exposed to dripping or splashing place. And don't put the objects that filled with liquids on the apparatus, such as vases.
• Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
• Do not install near any heat sources such as fire, radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
• Only use attachments / accessories specified by the manufacturer.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Do not overload wall outlets and extension cords as this can result in a risk or fire or electric shock.
• When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may result in fire or electric shock or other hazards.

SPECIFICATIONS

AC ADAPTOR

Input: AC100-240V ~ 50/60Hz

Output: DC 15V 2.0A

RECHARGEABLE BATTERY

Battery Type: 12V 2600mAh Lead-acid Battery

Operating Time: Approx. 5 hours at 50% volume after fully charged

Charging Time: Approx. 3 hours

BLUETOOTH

Bluetooth Version: V4.2+EDR

Bluetooth: 2.402-2.48GHz

RF Output Power: -0.58 dBm

Bluetooth working distance: Up to 10 meters measured in open space. (Wall and structures may affect range of device)

Specifications are subject to change without notice.

SAFETY INSTRUCTION

ATTENTION: To reduce the risk of electric shock, do not remove the cover or back. There are no user serviceable parts inside the unit. Refer all servicing to qualified personnel.

The lightning flash with arrowhead symbol within the triangle is a warning sign alerting the user of "dangerous voltage" inside the unit.

The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product.

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

If at any time in the future you should need to dispose of this product please note that Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)

NEW ONE S.A.S
10, Rue de la Mission, 25480 Ecole Valentin, France