Operation; Work Light - Clarke JSM1000 Operating & Maintenance Instructions

OPERATION

WORK LIGHT

1. Push and hold the ON/OFF button
for 3 seconds to turn the work light
on.
2. Push the ON/OFF button again.
• The worklight flashes on and off.
3. Push the ON/OFF button again.
• The work light flashes with the
morse code S-O-S pattern.
4. Push the ON/OFF button again to
turn the work light off.
USB OUTPUT POWER SUPPLY
The USB sockets supply a maximum of
3A at 5V.
1. Plug the 3 in 1 USB cable into
either of the USB sockets.
2. Connect the other end of the
appropriate cable to your
device(s).
3. Push the ON/OFF button to start
supplying power.
SMART CABLE STATUS DISPLAY
The status of the device is shown by the LED display on the smart jumper cable
as follows;
• Low voltage - Red LED solid
• Ready to start - Green LED solid
• Short circuit - Red LED solidand bleeping
• Reverse polarity - Red LED solidand bleeping
• Reverse charge - Red LED solidand bleeping
• Overheating - Red LED solidand bleeping
• Overcurrent - Green and red LED both solid
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
7