Operation - Clarke JS4000 Operation & Maintenance Instructions Manual

Hide thumbs Also See for JS4000:
Table of Contents

Advertisement

OPERATION

WARNING: FAILURE TO FOLLOW THE INSTRUCTIONS BELOW AND THE
SAFETY INSTRUCTIONS ON PAGES 3/4, MAY RESULT IN PERSONAL INJURY,
DAMAGE TO THE VEHICLE, OR THE POSSIBILITY OF AN EXPLOSION
Always carry out the following preliminary checks before connecting the
jump-start to the car battery:
• Ensure the vehicle ignition and ALL ancillary equipment - lighting,
radio etc, is switched off.
• Ensure the vehicle battery is rated at 12V and is not damaged in any
way.
• Ensure the battery terminals are clean and the clamps are firm and
secure.
• Remove any vehicle battery filler plugs and check the electrolyte
level. If necessary, top up with distilled water.
• Ensure the area is well ventilated.
• Take great care not to touch the red positive (+) clamp against the
black negative (-) clamp.
1. Ensure the ON/OFF switch is in the OFF position.
2. Connect the red positive (+) clamp to the positive (+) battery terminal first.
Take care the clamp does not contact any moving parts or fuel lines.
3. Connect the black negative (-) clamp to the negative (-) battery terminal
or to a suitable earthing point on the vehicle chassis ensuring the
connections are firm and secure.
• If the polarity is incorrect, and audible warning will sound.
Disconnect IMMEDIATELY and reverse the clamp connections.
4. Switch the Jump-start, then the vehicle ignition 'ON' and leave in this
condition FOR APPROX TWO MINUTES. (This will provide the vehicle battery
with a short 'boost' charge to allow for easier starting).
5. Switch the ignition to 'start', for NO MORE than 6 seconds.
• If the engine does not start, within this time, SWITCH OFF the ignition
and wait for at least 3 minutes before trying again to prevent
damage to the jumpstarter due to overheating before trying again.
After this cooling off period, it is safe to resume trying to start the
vehicle.
6. Once the vehicle has started, turn the jump-start ON/OFF switch OFF.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

6240030

Table of Contents