Craftsman 48"MOWER 917.24985 Owner's Manual page 5

1
BAGGER SUPPORT ASSEMBLY
(See Figs. 1A & 1B)
1.
Remove and discard the upper bolt on both sides of
the drawbar. Using the same holes, install the shoulder
bolts supplied and tighten securely.
REMOVE AND DISCARD
UPPER BOLTS ANDINSTALL
SHOULDER BO_SSUPPLIED
DRAWBAR
FIG, 1A
2. Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
3. Be sure support assembly is seated properly and secure
with retainer spring supplied.
SHOULDER
BOLTS
SUPPORT
ASSEMBLY
RETAINER
SPRING _d _.I °
\
PIN
FIG. 1B
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting cover assembly
to tractor.
1. Position cover assembly on ground behind tractor as
shown.
2. Lift and rotate cover to align cover brackets with support
assembly tubes.
3. Slide cover assembly down onto the support tubes.
COVER
SUPPORT
ASSEMBLY
5
02532
FIG. 2