Operation - U-Line H-9856MAP Manual

2. Align the two partially installed bolts with slotted
holes in stool plate and slide into plate.
(See Figure 2)
Figure 2
Stool Plate
MOVING TABLE
To avoid table tipping over, push from end of folded table,
facing the center lock rod. (See Figure 4)
CAUTION! Pushing from the flat table side may
cause tipping.
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
3. Install third and fourth bolts into stool plate. Tighten
bolts using ratchet or drill. Repeat on remaining
stools. (See Figure 3)

OPERATION

OPENING TABLE TO IN-USE POSITION
1. Disengage storage latch to release table from
storage position. Grasp table edge and pull
outward. (See Figure 5)
NOTE: Do not overtighten. If using drill, ensure it
is set to the lowest clutch setting.
Figure 3
Figure 5
1023 IH-9856