Setting Up Digital Channels (Mso2000 Series Only) - Tektronix DPO2024 User Manual

Acquire the Signal
When decoding an RS-232 bus in ASCII
mode, a large dot indicates that the value
represents a character outside the printable
ASCII range.

Setting Up Digital Channels (MSO2000 Series Only)

Use front-panel buttons and knobs to set up your oscilloscope to acquire signals using the digital channels available
only on MSO2000 models.
1. Connect the P6316 digital probe to the input
signal source.
2. Connect the ground lead or leads to the
circuit ground.
You can connect one or two of the common
ground leads for each group of 8 channels
(wires).
3. If needed, connect the appropriate grabber
for each channel to the probe tip.
4. Connect each channel to the desired circuit
test point.
5. Push the D15 - D0 front panel button to
display the menu.
60 DPO2000 and MSO2000 Series Oscilloscopes User Manual