Table of Contents
Advertisement
33-MAINTENANCE AND CLEANING
EXAMPLE OF A CLEAN BRAZIER
Only by properly servicing and cleaning the product is it possible to ensure its safety and correct operation.
ATTENTION!
All the cleaning operations of all parts must be performed with the product completely cold and the plug
disconnected. Disconnect the product from the 230V power supply before performing any maintenance operation.
The product requires little maintenance if used with certified good quality pellets.
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
Brazier cleaning
Before ignition, always clean the brazier "b" and remove any ash or incrustation from it that might obstruct the air flow holes, paying
attention to hot ash. In the case of ignition failure, or if fuel in the hopper runs out, unburned pellets may accumulate in the brazier.
Always empty the residue in the brazier before each start-up. Only if ash is completely cold may a vacuum cleaner be used to remove
it. In this case, use a suitable vacuum cleaner to remove small sized particles.
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE IGNITION AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT. IN CASE OF FAILED IGNITION AND AFTER ANY OTHER LOCK STATE OF THE
PRODUCT, IT IS ESSENTIAL TO EMPTY THE BRAZIER BEFORE EVERY
Technical Dept. - All rights reserved - Reproduction prohibited
b
EXAMPLE OF A DIRTY BRAZIER
RESTART.
49
Advertisement
Table of Contents
