Touch Control - Venduro TA-600 Manual

ENG

Touch control.

When the motor is active, the LEDs on the touch control constantly present the current status
(speed and filter).
2 Buttons
• Light on/off:
• Motor on/off:
5 LEDs
• 3 speeds + boost function
• Filter indication
When the motor is started by pressing on the
Another press on the
Once the motor is already at boost level, pressing the
So the successive levels are 0-1-2-3-boost-0-1-2-3-boost, etc.
The boost speed can only be active for a certain period, after which the exhaust will drop back to level 1.
The shut-off delay time can be activated by pressing on the
the motor is active.
The lighting is switched on/off by a short press on the
will cause the lighting to begin to dim. When the lighting is at the minimum level, the lighting will
begin to return towards the maximum. If the user thus continues to dim, the lighting will dim
continuously between the minimum and maximum strength.
After the motor has worked for a certain period, the filter must be cleaned. Once this filter period
has passed, the filter LED on the touch interface or the remote control will light up. The filter time-out
can only be reset if the filter time has actually passed.
Via the touch control the filter time-out can be reset by holding down both buttons
for an extended time.
44
All manuals and user guides at all-guides.com
can be held down longer in order to dim
can be held down for a shorter or longer time
button increases the speed by 1 level.
button, it begins at level 1.
button again will turn the motor off.
button for an extended time while
button. Continuing to press on the button
(and)